$HEADER

"Draw" PlugIT

The "Draw" plugIT allows to create a drawing surface on the 3D view

 

Parameters

1

Allows to apply the drawing surface to an object.

2

The object on which to apply the drawing surface.

3

The material on which to apply the drawing surface.

4

The material technique on which to apply the drawing surface.

5

The technique pass on which to apply the drawing surface.

6

The texture on which to apply the drawing surface.

7

If checked, the drawing surface will appear in the background.

8

Sets the X (horizontal) position of the drawing surface. By default the units are in pixels. Check "%" to change the units to percentage. The offset parameter is then accessible and allows to add an additional offset in pixels. The drop-down list allows to select the alignment from which the position is set, left, center, or right.

9

Sets the Y (vertical) position of the drawing surface. By default the units are in pixels. Check "%" to change the units to percentage. The offset parameter is then accessible and allows to add an additional offset in pixels. The drop-down list allows to select the alignment from which the position is set, top, center, or bottom.

10

Sets the width of the drawing surface. By default the units are in pixels. Check "%" to change the units to percentage. The offset parameter is then accessible and allows to add an additional offset in pixels.

11

Sets the height of the drawing surface. By default the units are in pixels. Check "%" to change the units to percentage. The offset parameter is then accessible and allows to add an additional offset in pixels.

12

Color used for drawing.

13

Brush size in pixels.

14

Opacity of the drawing surface

15

Enables the transparency

16

If checked, allows you to draw on the drawing surface with the mouse or the VR controllers.

17

Loads the saved drawing on application startup.

18

Show the drawing surface on application startup.


 

Actions

Draw

Draws a point at the coordinates given a link parameter.

Export

Exports the drawing in .png or .jpg format in the Pictures\drawing folder.

Hide

Hides the drawing surface.

Show

Shows the drawing surface.

Load

Loads the saved drawing.

Save

Saves the drawing.

Undo

Deletes the previous brush stroke.

Redo

Redo an undone brush stroke.

New drawing

Ends the current brush stroke. Allows to separate the strokes for the use of Undo / Redo actions when the drawing is performed via the Draw action

Set brush color

Changes the drawing color by the color given in link parameter in rgba format (example: ff0000ff for opaque red).

Set brush size

Changes the brush size to the one given in the link parameter.

Clear

Clears the drawing surface.

$FOOTER